![]() Hdmi_mode=81 uncomment to force a HDMI mode rather than DVI. Hdmi_force_hotplug=1 uncomment to force a specific HDMI mode (this will force VGA) framebuffer_width=1366 framebuffer_height=768 uncomment if hdmi display is not detected and composite is being output By default it will be display's size minus overscan. Use positive numbers if console goes off screen, and negative if there is too much border overscan_left=30 overscan_right=15 overscan_top=20 overscan_bottom=10 uncomment to force a console size. Hdmi_safe=1 disable_commandline_tags=1 uncomment this if your display has a black border of unused pixels visible and your display can output without overscan disable_overscan=1 hdmi_ignore_edid_=0xa5000080 uncomment the following to adjust overscan. When I power on my retropie, all is quiet until around the time the retropie splashscreen comes on. ![]() I purchased this hdmi to vga adapter that I also use for my audio out as opposed to the 3.5mm jack. " uncomment if you get no picture on HDMI for a default "safe" mode I have a retropie (rpi3b running retropie 4.4.) powering my arcade cabinet that has an lcd monitor in it that is vga only. ![]() So, to configure my retropie, i wrote this in /boot/config.txt :
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |